Dell Inspiron One 2310 Intel Service Manual

Also see for Inspiron One 2305: Setup guide Service manual Service manual

Back to Contents PageProcessor Heat-Sink FanDell™ Inspiron™ One 2305/2310 Service ManualRemoving the Processor Heat-Sink FanReplacing the Processor Heat-Sink FanRemoving the Processor Heat-Sink Fan1. Follow the instructions in Before You Begin.2. Remove the back cover (see Removing the Back Cover).3. Follow the instructions from step 2 to step 5 in Removing the Front Stand.4. Remove the system-board shield (see Removing the System-Board Shield).5. Disconnect the processor heat-sink fan cable from the connector (CPU FAN) on the system board.6. Remove the two screws that secure the processor heat-sink fan to the chassis.7. Carefully peel the silver foil from the processor heat sink.8. Lift the processor heat-sink fan along with its cable away from the chassis.Replacing the Processor Heat-Sink Fan1. Follow the instructions in Before You Begin.2. Align the screw holes on the processor heat-sink fan with the screw holes on the hex nut screws.3. Replace the two screws that secure the processor heat-sink fan to the chassis.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: The heat sink may be very hot during normal operation. Ensure that it has had sufficient time to cool before you touch it.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).NOTE: The appearance of the system board may vary based on your computer model.1 processor heat-sink fan cable 2 processor heat-sink fan3 screws (2)