106 Adding and Replacing PartsNOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodicallytouching an unpainted metal surface (such as a connector on the back of the computer).NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay beforeyou begin working inside the computer.1 Follow the procedures in "Before You Begin" on page 89.2 Remove the hinge cover. See "Hinge Cover" on page 99.3 Remove the six screws securing the display (two on the top, two on the bottom, and two on the back).4 Disconnect the antenna cables from the Mini-Card.5 Loosen the captive grounding-wire screw.6 Disconnect the display cable, using the pull-tab.7 Dislodge the display cable from the display cable channel.1 screws (2) 2 display cable 3 display cable pull-tab4 grounding-wire screw 5 antenna cables (2) 6 standby switch7 display cable connector onsystem board8 display cable channel2 351 4786book.book Page 106 Wednesday, April 4, 2007 7:31 AM
