| 
monitor is not connected, the computer's display shuts off and the computer enters suspend mode (standby mode in Microsoft® Windows® 98).To resume work, open the display. (The computer may take several seconds to resume operation.)Suspend ModeIf your computer is running the Microsoft Windows 95 or Microsoft Windows NT® operating system, suspend mode stops almost all computeractivity, but leaves the computer ready to resume operations immediately in about 20 to 30 seconds. Use suspend mode whenever you leave thecomputer unattended.NOTICE: Windows 95 and Windows NT save data to random-access memory (RAM), not to your hard-disk drive, before enteringsuspend mode. If the computer enters suspend mode while running on battery power, data loss from RAM can occur if the batterydischarges completely.Suspend mode conserves battery power by turning off the microprocessor clock; the display; the hard-disk drive; the CD-ROM, DVD-ROM, or LS-120 drive module (if installed); the external monitor connector; the external keyboard (if attached); the parallel port; the serial port; the touch pad;and the diskette drive.You can enter suspend mode immediately by pressing (or on an external keyboard if the External Hot Keyoption is enabled in the System Setup program).When you enter suspend mode, the power indicator is not lit.Resume from suspend mode by pressing the power button. The computer may take several seconds to return to normal operation.Standby ModeIf your computer is running the Microsoft Windows 98 operating system, standby mode turns off the display, stops the hard-disk drive, and turns offother internal devices so that the computer uses less battery power. When the computer resumes operation from standby mode, the desktop isrestored exactly as it was before entering standby mode.NOTICE: Windows 98 saves data to random-access memory (RAM), not to your hard-disk drive, before entering standby mode. If thecomputer enters standby mode while running on battery power, data loss from RAM can occur if the battery discharges completely.You can enter standby mode by pressing . To resume operation from standby mode, press the power button.Suspend-to-Disk ModeSuspend-to-disk (S2D) mode copies all system data to a reserved area—the S2D partition—on the hard-disk drive and then turns off all power tothe computer. When you resume normal operation, the same programs will be running and the same files will be open that were loaded before youactivated this mode.Place the computer in S2D mode if you intend to store the computer for longer than 40 days. S2D mode preserves the configuration informationstored in nonvolatile random-access memory (NVRAM). The reserve battery maintains this information, but it may run out of energy after 40 days.If your system is running under Advanced Power Management (APM) mode, and if the External Hot Key option is enabled in the System Setupprogram, you can enter S2D mode by pressing (or on an external keyboard). On a French keyboard, press or .* Resume operation from S2D mode by pressing the power button.If you connect or remove devices while the computer is in S2D mode, the computer automatically recognizes the newly connected devices when itresumes normal operation.Some PC Cards may not operate correctly after resuming from S2D mode. If you encounter problems with a card, remove and reinsert the card.NOTE: If an external monitor is connected when you close the display, the computer does not activate suspend mode. You can still usethe external monitor.NOTES: On resumption from suspend mode, if a password is set, the computer displays the password prompt screen. At the passwordprompt screen, if you do not enter a password within 2 minutes, the computer returns to suspend mode.Suspend mode is known as standby mode under the Microsoft Windows 98 operating system.NOTE: S2D mode helps preserve system data by quickly saving it to the hard-disk drive if you are about to run out of battery power.NOTE: Dell creates an appropriately sized S2D partition before shipping the computer to you. Use the S2D utility to remove the file, toincrease the size of the file, or to add the S2D file if you removed it. For more information about altering or creating an S2D file, see the |
