The computer recognizes most PC Cards and automatically loads the appropriate device driver. If the configuration program tells you to load themanufacturer's drivers, use the floppy or CD that came with the PC Card.Removing a PC Card or Blank1. Press the latch and remove the card or blank. For some latches, you must press the latch twice: once to pop the latch out, and then a second time topop the card out.2. Remove the card or blank.Save a blank to use when no PC Card is installed in a slot. Blanks protect unused slots from dust and other particles.Back to Contents PageNOTICE: Use the PC Card configuration utility (click the icon in the taskbar) to select a card and stop it from functioning before you remove it fromthe computer. If you do not stop the card in the configuration utility, you could lose data. Do not attempt to eject a card by pulling its cable, if one isattached.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.NOTE: This computer uses digital sound, and contains no analog audio lines. PCMCIA cards such as modems that use analog lines to produce sound willnot function.
