Dell N1108T-ON Getting Started Manual

Also see for N1108P-ON: Getting started guide

22 Getting Started Guidewith normal operation using the default systemconfiguration. Note: You can exit the setup wizard atany point by entering [ctrl+z].Would you like to run the setup wizard (you mustanswer this question within 60 seconds)? [Y/N] yStep 1:The system is not set up for SNMP management bydefault. To manage the switch using SNMP (required forDell Network Manager) you can. Set up the initial SNMP version 2 account now.. Return later and set up other SNMP accounts. (Formore information on setting up an SNMP version 1 or3 account, see the user documentation).Would you like to set up the SNMP management interfacenow? [Y/N] yTo set up the SNMP management account you must specifythe management system IP address and the “communitystring” or password that the particular managementsystem uses to access the switch. The wizardautomatically assigns the highest access level[Privilege Level 15] to this account. You can use DellNetwork Manager or other management interfaces tochange this setting, and to add additional managementsystem information later. For more information onadding management systems, see the user documentation.To add a management station:Please enter the SNMP community string to be used.[public]: publicNOTE: If it is configured, the default access level is set to the highest availableaccess for the SNMP management interface. Initially only SNMPv2 will beactivated. SNMPv3 is disabled until you return to configure security access forSNMPv3 (e.g. engine ID, view, etc.).Please enter the IP address of the Management System(A.B.C.D) or wildcard (0.0.0.0) to manage from anyManagement Station. [0.0.0.0]: 10.1.2.100