Dell N1108T-ON Getting Started Manual

Also see for N1108P-ON: Getting started guide

Getting Started Guide 7N1108T-ON/N1108P-ON InstallationRack Mounting an N1108T-ON/N1108P-ON SwitchWARNING: Read the safety information in theSafety and Regulatory Informationas well as the safety information for other switches that connect to or support theswitch.The AC power connector is on the rear panel of the switch.Installing in a RackWARNING: Do not use rack mounting kits to suspend the switch from under atable or desk, or attach it to a wall.CAUTION: Disconnect all cables from the switch before continuing. Remove allself-adhesive pads from the underside of the switch, if they have been attached.CAUTION: When mounting multiple switches into a rack, mount the switchesfrom the bottom up.1 Secure the N1108T-ON/N1108P-ON switch in either the Dell Rack MountKit as shown in Figure 1-1 or the Dell Tandem Tray Kit as shown inFigure 1-2.Figure 1-1. Dell Rack Mount Kit