Dell N2128PX-ON Getting Started Manual

Also see for N2128PX-ON: Upgrading Firmware Upgrading Software and Firmware

Getting Started Guide 17Example SessionThis section describes a Dell Easy Setup Wizard session. The followingvalues are used by the example session:• The SNMP community string to be used is public.• The network management system (NMS) IP address is 10.1.2.100.• The user name is admin, and the password is admin123.• The IP address for the VLAN 1 routing interface is 10.1.1.200 with asubnet mask of 255.255.255.0.• The default gateway is 10.1.1.1.The setup wizard configures the initial values as defined above. Aftercompleting the wizard, the switch is configured as follows:• SNMPv2 is enabled and the community string is set up as defined above.SNMPv3 is disabled by default.• The admin user account is set up as defined.• A network management system is configured. From the managementstation, you can access the SNMP, HTTP, and CLI interfaces. You may alsochoose to allow all IP addresses to access these management interfaces bychoosing the (0.0.0.0) IP address.• An IP address is configured for the VLAN 1 routing interface.• A default gateway address is configured.NOTE: In the following example, the possible user options or default values areenclosed in [ ]. If you press with no options defined, the default value isaccepted. Help text is in parentheses.