Dell OptiPlex 9010 AIO Owner's Manual

Also see for OptiPlex 9010 AIO: Setup and features information

Contents

Installing the Intrusion Switch1. Place the intrusion switch on the computer and tighten the screw to secure it to the chassis.2. Thread the cable along the notches on the chassis and connect the intrusion switch to the connector on the systemboard.3. Install:a) system-board shieldb) VESA mount bracketc) back coverd) VESA stand4. Follow the procedures inAfter Working Inside Your Computer.Removing the Wireless Local Area Network (WLAN) Card1. Follow the procedures inBefore Working Inside Your Computer.2. Remove the:a) VESA standb) back coverc) VESA mount bracketd) system-board shield3. Disconnect the WLAN cables. Remove the screws that secure the WLAN card to the system board. Remove theWLAN card from the connector.18