Troubleshooting Your System 1095 Ensure that each expansion card is firmly seated in its connector. See "Installing an Expansion Card"on page 72.6 Close the system. See "Closing the System" on page 47.7 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.If the problem persists, go to the next step.8 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.9 Open the system. See "Opening the System" on page 43.10 Remove all expansion cards installed in the system. See "Removing an Expansion Card" in "InstallingSystem Components."11 Close the system. See "Closing the System" on page 47.12 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.13 Run the appropriate online diagnostic test.If the tests fail, see "Getting Help" on page 121.14 For each expansion card you removed in step 10, perform the following steps:a Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.b Open the system. See "Opening the System" on page 43.c Reinstall one of the expansion cards.d Close the system. See "Closing the System" on page 47.e Run the appropriate diagnostic test.If the tests fail, see "Getting Help" on page 121.Troubleshooting the MicroprocessorProblem• Error message indicates a microprocessor problem.• A heat sink is not installed for the processor.ActionCAUTION: Only trained service technicians are authorized to remove the system cover and access any of thecomponents inside the system. Before performing any procedure, see your Product Information Guide forcomplete information about safety precautions, working inside the computer and protecting against electrostaticdischarge.1 If possible, run the appropriate online diagnostics test.2 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.3 Open the system. See "Opening the System" on page 43.
