76 Configuration: About Your Storage ArrayPassword GuidelinesFollow these guidelines when you create a password:• Use secure passwords for your storage array. A password must be easy foryou to remember but difficult for others to determine. Consider usingnumbers or special characters in the place of letters, such as a 1 in theplace of the letter I, or the at sign (@) in the place of the letter a.• For increased protection, use a long password with at least 15alphanumeric characters. The maximum password length is 30 characters.• Passwords are case sensitive.NOTE: You can attempt to enter a password up to ten times before the storagearray enters a lockout state. Before you can try to enter a password again, you mustwait 10 minutes for the storage array to reset. To reset the password, press thepassword reset switch on your RAID controller module, see Figure 3-1.Viewing Storage Array ConnectionsYou can use the View Connections option to view the expansion enclosuresconnected to the RAID controller module.To view the storage array connections:1 From the toolbar in AMW, select Storage ArrayViewConnections.The :Connections dialog is displayed.2 Click the column name to sort the connections according to your preference.3 Click Close.If you receive an error message for a port, you can use this dialog to identifythe components on the port that may have caused the error. By isolating thesecomponents, you prevent accidentally disconnecting components that arestill in operation, which could cause an interruption in data flow.
