194 Installing System ComponentsInstalling a Compute SledCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized is not covered bywarranty. Read and follow the safety instructions that came with the product.1 Orient the sled so that the release latch is in the bottom of the sled. SeeFigure 3-4 or Figure 3-5.2 Slide the new sled into the enclosure until the sled is fully seated and therelease latch snaps into place. See Figure 3-4 or Figure 3-5.Storage SledRemoving a Storage SledCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized is not covered bywarranty. Read and follow the safety instructions that came with the product.CAUTION: To ensure proper airflow in the system, if a sled is removed it should beimmediately replaced with another sled or sled blank.CAUTION: Operating the system without a sled or sled blank installed can causethe enclosure to overheat. See "Installing a Double-Wide Sled Blank" on page 190.1 Pull and hold the storage sled release tab at the bottom of the sled todisengage the sled from the server enclosure. See Figure 3-6.2 Using the handle, slide the sled out of the enclosure. See Figure 3-6.
