Updating Firmware Images and Monitoring the PDU Power Status 2772 Install a Trivial File Transfer Protocol (TFTP) server software on yourcomputer.TFTP is a simplified form of the FTP. It is used with the SNMP v2ccommand line interfaces to transfer files to and from the FCB, update theFCB firmware and modify the FCB configuration information.If you are using Linux, install a TFTP server from your distribution.If you are using Windows, install a commercial or free TFTP server.Checking FCB IndicatorsThe FCB status and identification indicators light to indicate an errorcondition.• Status indicator blinks amber (about 1 Hz) to indicate an error condition.• Identification indicator blinks blue (about 1 Hz).Resetting the FCB Network ConnectionBy default, the FCB is configured to automatically obtain an IP address viaDHCP server.1 Do three short presses of the reset button within 5 seconds to change theDHCP IP address on the FCB over to a static IP address.After the FCB resets, all network and configuration settings restore back totheir default values. The FCB is configured with the following defaultnetwork settings:• IP address: 192.168.0.120• Subnet mask: 255.255.255.0• Gateway: 192.168.0.1The status indicator on the FCB displays the following behaviors:• Blinking amber (500 ms off/5 s on) — Restarts the FCB firmware andreset to factory default is completed.• Blinking amber (250 ms off/5 s on) — Restores the default networksettings to their default values.2 Do three short presses of the reset button within 5 seconds again to switchstatic IP back to reset to default (DHCP).
