230 Monitoring and Logging System InformationConfiguring Email Alerts for Log MessagesBeginning in Privileged EXEC mode, use the following commands toconfigure email alerts so that log messages are sent to the specified address.Command Purposeconfigure Enter Global Configuration mode.logging email [severity] Enable email alerting and determine which non-critical logmessages should be emailed. Including theseverity valuesets the lowest severity for which log messages are emailed.These messages are collected and sent in a single email atthe configured log duration.severity — (Optional) Enter the number or name of theseverity level for non-critical messages. Log messages at orabove this severity level are emailed. For information aboutseverity levels, see Table 11-1. Log messages below thespecified level are not emailed.logging email urgent{severity | none}Determine which log messages are critical and should besent in a single email as soon as they are generated.severity — (Optional) Enter the number or name of theseverity level for critical messages. For information aboutseverity levels, see Table 11-1.logging email logtimeminutesSpecify how often to send the non-critical email alerts thathave been collected. . The valid range is 30 - 1440 minutes.logging email message-type {urgent | non-urgent | both} to-addremail-addressSpecify the email address of the recipient for log messages.logging email from-addremail-addressSpecify the email address of the sender, which is theswitch.logging email message-type {urgent | non-urgent | both} subjectsubjectSpecify the text that will appear in the subject line of emailalerts sent by the switch.
