Dell PowerConnect 8024 User Configuration Manual

Also see for PowerConnect 8024: Release notes Release note Upgrading Firmware Cli reference guide User guide

Contents

Dell PowerConnect 8024 User Configuration Manual Manual pdf 725 page image

Configuring L2 Multicast Features 725Configuring L2 Multicast Features (CLI)This section provides information about the commands you use to configureL2 multicast settings on the switch. For more information about thecommands, see thePowerConnect 8024/8024F/8132/8132F/8164/8164F CLIReference Guide at support.dell.com/manuals.Configuring Bridge MulticastingBeginning in Privileged EXEC mode, use the following commands toconfigure MAC address table features.Command Purposeconfigure Enter global configuration mode.mac address-tablemulticast filteringEnable multicast filtering on the switch.mac address-tablemulticast static vlanvlan-id {mac-multicast-address | ip-multicast-address}Register a MAC-layer Multicast address in the bridgetable.•mac-multicast-address — MAC multicast address in theformat xxxx.xxxx.xxxx.•ip- multicast-address — IP multicast address.mac address-tablemulticast static vlanvlan-id {mac-multicast-address | ip-multicast-address} [add|remove]interfaceinterface-listAdd ports and LAGs to the multicast group as staticmembers.• add — Adds ports to the group. If no option is specified,this is the default option.• remove — Removes ports from the group.•interface-list — Specifies the interface type (port-channel, tengigabitethernet) and number. Separatenonconsecutive interfaces with a comma and no spaces;use a hyphen to designate a range of ports.