BigIron RX Installation Guide 11553-1001811-01Managing the BigIron RX Series chassis 5Displaying the Syslog configuration and static anddynamic buffersFor information about configuring Syslog, refer to the BigIron RX Series Configuration GuideTo display the Syslog parameters currently in effect on a BigIron RX Series switch, enter thefollowing command from any level of the CLI:Syntax: show loggingThe Syslog display shows the following configuration information, in the rows above the log entriesthemselves.Status The status of a fan can be one of the following:• OK – The fan is functioning properly and is keeping the temperature ofeach module within an acceptable temperature range.• Failed – The fan is not functioning properly or the fan control modulecannot control the fan.Speed The speed of a fan can be one of the following:• Low – The fan is functioning at 50 percent of capacity.• Medium – The fan is functioning at 75 percent of capacity.• Medium-high – The fan is functioning at 90 percent of capacity.• High – The fan is functioning at 100 percent of capacity.Temperature ReadingsActive and Standby Mgmt Module The temperature of the active and standby management modules.Fan The temperature of fan0 and fan1.SNM The temperature of the switch fabric module.Temperature Monitoring Poll Period The interval at which the system reads the temperature sensor on themanagement, switch fabric, interface, and fan control modules.Misc InfoBackplane EEPROM MAC Address The MAC address of the BigIron RX Series chassis.TABLE 19 Syslog buffer configurationThis field... Displays...Syslog logging The state (enabled or disabled) of the Syslog buffer.messages dropped The number of Syslog messages dropped due to user-configured filters.By default, the software logs messages for all Syslog levels. You candisable individual Syslog levels, in which case the software filters outmessages at those levels. Each time the software filters out a Syslogmessage, this counter is incremented.TABLE 18 Chassis status and temperature information (Continued)This field... Displays...BigIron RX> show loggingSyslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)Buffer logging: level ACDMEINW, 7 messages loggedlevel code: A=alert C=critical D=debugging M=emergency E=errorI=informational N=notification W=warning...
