146 BigIron RX Installation Guide53-1001811-01Replacing a fiber-optic transceiver6Follow the steps given below to remove a fiber-optic transceiver from a 10 Gigabit Ethernet port.1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connectorlocated in the upper right corner of the chassis front.2. Disconnect the two fiber cable connectors from the port connectors.3. Insert the protective covering into the port connectors.4. Pull down the latch on the front of the transceiver.5. Pull the transceiver out of the port, and place it in an anti-static bag for storage, if desired.6. Install a new fiber-optic transceiver in the port. For information about performing this task,refer to “Installing a new fiber-optic transceiver” next.Installing a new fiber-optic transceiverYou can install a new fiber-optic module (SFP or XFP transceiver) in each Gigabit Ethernet and 10Gigabit Ethernet port while the BigIron RX Series chassis is powered on and running.Before installing one of these modules into the port, have the following on hand:• A new fiber-optic module, which you can order from Brocade• An ESD wrist strap with a plug for connection to the ESD connector on the BigIron RX SerieschassisDANGERFor safety reasons, the ESD wrist strap should contain a 1 meg ohm series resistor.Follow the steps given below to install a fiber-optic module into a 10 Gigabit Ethernet port.1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connectorlocated in the upper right corner of the chassis front.2. Remove the new module from its protective packaging.3. Gently insert the fiber-optic module into the port until the module clicks into place. Thefiber-optic modules are keyed to prevent incorrect insertion.Cabling a fiber-optic transceiverFollow the steps given below to cable a fiber-optic module.1. Remove the protective covering from the fiber-optic port connectors and store the covering forfuture use.2. Before cabling a fiber-optic module, Brocade strongly recommends cleaning the cableconnectors and the port connectors. For more information,refer to “Cleaning fiber opticmodules” on page 108.3. Gently insert the two cable connectors (a tab on each connector should face upward) into theport connectors until the tabs lock into place.4. Observe the link and active LEDs to determine if the network connections are functioningproperly. For more information about the LED indicators, refer to Table 16 on page 109.
