}ethernet-switching-options {storm-control {interface all;}}poe {interface all;}RelatedDocumentationConnecting and Configuring a J-EX Series Switch (CLI Procedure) on page 131•• Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 133• For information about J-EX Series switch configuration files and interfaces andinstructions for reverting to the factory default configuration, see the Dell PowerConnectJ-Series Ethernet Switch Complete Software Guide for Junos OS athttp://www.support.dell.com/manuals.Connecting and Configuring a J-EX Series Switch (CLI Procedure)There are two ways to connect and configure a J-EX Series switch: one method is throughthe console using the CLI and the other is using the J-Web interface. This topic describesthe CLI procedure.NOTE: To run the ezsetup script, the switch must have the factory defaultconfiguration as the active configuration. If you have configured anything onthe switch and want to run ezsetup, revert to the factory default configuration.For instructions, see the Dell PowerConnect J-Series Ethernet Switch CompleteSoftware Guide for Junos OS at http://www.support.dell.com/manuals.Before you begin connecting and configuring a J-EX Series switch through the consoleusing the CLI:• Set the following parameter values in the console server or PC:• Baud Rate—9600• Flow Control—None• Data—8• Parity—None131Chapter 12: Performing Initial Configuration
