Connecting and Configuring a J-EX Series Switch (J-Web Procedure)There are two ways to connect and configure a J-EX Series switch: one method is throughthe console using the CLI and the other is using the J-Web interface. This topic describesthe J-Web procedure.NOTE: Before you begin the configuration, enable a DHCP client on themanagement PC you will connect to the switch so that the switch can obtainan IP address dynamically.NOTE: Read the following steps before you begin the configuration. Youmust complete the initial configuration using EZSetup within 10 minutes. Theswitch exits EZSetup after 10 minutes and reverts to the factory defaultconfiguration, and the PC loses connectivity to the switch. The LCD displaysa count-down timer when the switch is in initial setup mode.To connect and configure the switch using the J-Web interface:1. To transition the switch into initial setup mode, use the Menu and Enter buttons locatedto the right of the LCD panel (see Figure 55 on page 133):Figure 55: LCD Panel in a J-EX4200 Switcha. Press the Menu button until you see MAINTENANCE MENU. Then press the Enterbutton.b. Press Menu until you see ENTER EZSetup. Then press Enter.If EZSetup does not appear as an option in the menu, select Factory Default toreturn the switch to the factory default configuration. EZSetup is displayed in themenu only when the switch is set to the factory default configuration.c. Press Enter to confirm setup and continue with EZSetup.2. Connect the Ethernet cable from the Ethernet port on the PC to port 0 (ge-0/0/0)on the front panel of the switch.The port is configured as the DHCP server with the default IP address, 192.168.1.1. Theswitch can assign an IP address to the management PC in the IP address range192.168.1.2 through 192.168.1.253.3. From the PC, open a Web browser, type http://192.168.1.1 in the address field, andpress Enter.133Chapter 12: Performing Initial Configuration
