Dell PowerConnect M6220 Configuration Manual

Also see for PowerConnect M6220: Release notes Configuration guide Cli reference guide Configuration guide Release note

Contents

Switching Configuration 31CLI ExamplesThe following examples show commands to use with the IGMP Snooping feature.Example #1: Enable IGMP Snooping on the SwitchNOTE: Before you enable IGMP Snooping on the switch, you must enable the filtering of multicast addresses withthe bridge multicast filtering command.console(config)#bridge multicast filteringconsole(config)#ip igmp snoopingExample #2: Enable IGMP Snooping on an Interfaceconsole(config)#interface ethernet 1/g1console(config-if-1/g1)#ip igmp snooping ?host-time-out Configure host time out parameter.leave-time-out Configure leave time out parameter.mrouter-time-out Configure mrouter time out parameter. Press enter to execute the command.console(config-if-1/g1)#ip igmp snoopingconsole(config-if-1/g1)#exitExample #3: Show IGMP Snooping Information for the Switchconsole#show ip igmp snoopingAdmin Mode..................................... EnableMulticast Control Frame Count.................. 0Interfaces Enabled for IGMP Snooping........... 1/g1Vlans enabled for IGMP snooping................ NoneExample #4: Show IGMP Snooping Information for an Interfaceconsole#show ip igmp snooping interface ethernet 1/g1Slot/Port...................................... 1/g1Global IGMP Snooping Admin Mode................ EnabledIGMP Snooping Admin Mode....................... EnabledFast Leave Mode................................ DisabledGroup Membership Interval...................... 260Max Response Time.............................. 10Multicast Router Present Expiration Time....... 300