Dell PowerConnect M6220 Configuration Manual

Also see for PowerConnect M6220: Release notes Configuration guide Cli reference guide Configuration guide Release note

Contents

Device Security 95Example #3: Apply the Rule to Outbound (Egress) Traffic on Port 1/g2Only traffic matching the criteria will be accepted.console(config)#interface ethernet 1/g2console(config-if-1/g2)#ip access-group list1 outconsole(config-if-1/g2)#exitMAC ACL CLI ExamplesThe following are examples of the commands used for the MAC ACLs feature.Example #4: Set up a MAC Access Listconsole#configconsole(config)#mac access-list extended mac1console(config)#exitExample #5: Specify MAC ACL Attributesconsole(config-mac-access-list)#deny ?any Configure a match condition for all the source MACaddresses in the Source MAC Address field. Enter a MAC Address.console(config-mac-access-list)#deny any ?any Configure a match condition for all the destinationMAC addresses in the Destination MAC Address field.bpdu Match on any BPDU destination MAC Address. Enter a MAC Address.console(config-mac-access-list)#deny any 00:11:22:33:44:55 ? Enter a MAC Address bit mask.console(config-mac-access-list)#deny any 00:11:22:33:44:55 00:00:00:00:FF:FF ?assign-queue Configure the Queue Id assignment attribute.cos Configure a match condition based on a COS value.log Configure logging for this access list rule.mirror Configure the packet mirroring attribute.redirect Configure the packet redirection attribute.vlan Configure a match condition based on a VLAN ID.<0x0600-0xffff> Enter a four-digit hexadecimal number in the range of0x0600 to 0xffff to specify a custom Ethertype value. Press enter to execute the command. Enter one of the following keywords to specify anEthertype (appletalk, arp, ibmsna, ipv4, ipv6, ipx,