Dell PowerConnect M8024 User Manual

Also see for PowerConnect M6220: Release notes Configuration guide Cli reference guide Configuration guide Release note

Contents

Dell PowerConnect M8024 User Manual Manual pdf 390 page image

388 Configuring Switching InformationThe Dynamic ARP Inspection Global Configuration page contains the following fields:• Validate Source MAC — Select the DAI Source MAC Validation Mode for the switch. If you selectEnable, Sender MAC validation for the ARP packets will be enabled. The default is Disable.• Validate Destination MAC—Select the DAI Destination MAC Validation Mode for the switch. If youselect Enable, Destination MAC validation for the ARP Response packets will be enabled. The defaultis Disable.• Validate IP—Select the DAI IP Validation Mode for the switch. If you select Enable, IP Addressvalidation for the ARP packets will be enabled. The default is Disable.Configuring Dynamic ARP Inspection With CLI CommandsFor information about the CLI commands that perform this function, refer to the following chapter intheCLI Reference Guide:• Dynamic ARP Inspection CommandsDAI Interface ConfigurationUse the DAI Interface Configuration page to select the DAI Interface for which information is to bedisplayed or configured.To display the DAI Interface Configuration page, click Switching > Dynamic ARP Inspection > DAIInterface Configuration in the navigation tree.