Dell PowerConnect W-AirWave 7.5 | Configuration Guide Configuration Reference | 993. Select Add or Save. The added or edited profile appears on the Mobility Switch page, and on the details page.Profiles > Mobility Switch > Ethernet LinkUse the Ethernet Link profile to configure autonegotiation, duplex, speed, and flow control for the port. Creatingan Ethernet Link profile does not apply the configuration to any interface or interface group.Perform these steps to configure a Mobility Switch > Ethernet Link profile:1. Select Profiles > Mobility Switch > Ethernet Link in the Navigation pane. The details page summarizes thecurrent profiles of this type.2. Select the Add button to create a new Ethernet Link profile, or select the pencil icon next to an existingprofile to edit. Complete the settings as described in Table 46:Query-response-interval (1-25sec)10 Specify the maximum query response time.Query-interval (1-18000 sec) 125 Specify the periodic interval at which queries are sent.Startup-query-interval (1-18000sec)31 Specify the interval at which startup queries should be sent.Enable Igmp Snooping Yes Enable or disable IGMP snooping.Robustness-variable (1-7) 2 Specify the expected IGMP packet loss on a congested network.Table 46 Profiles > Mobility Switch > Ethernet Link Profile SettingsField Default DescriptionGeneral SettingsFolder Top Set the folder with which the profile is associated. The drop-down menu displays all foldersavailable for association with the profile.Name Blank Enter the name of the profile.Other SettingsAutonegotiation Disabled Enables auto-negotiation of port speed.Duplex Auto Sets the duplex to one of the following parameters: Auto—Configures auto mode. full—Configures full duplex mode. half—Configures half duplex mode.Speed (Mbps) Auto Sets the speed to one of the following parameters: Auto—Negotiates bandwidth dynamically between 10 and 1000/10000. 10—10 Mbps. 100—100 Mbps. 10m_100m—10 to 100 Mbps. 1000—1 Gbps. 10000—10 Gbps.Flow Control off Sets the flowcontrol to one of the following parameters: Auto—Configures auto mode. lossless—configures lossless mode. on—configures on mode. off—configures off mode.Table 45 Profiles > Mobility Switch > IGMP Snooping Profile Settings (Continued)Field Default Description
