Dell PowerConnect W-AirWave 7.4 | User Guide Using VisualRF | 259To enable VisualRF, follow these instructions while logged in as an administrator:1. Go to AMP Setup > General.2. Scroll down to the AMP Features section as shown in Figure 187. In the field Display VisualRF, select Yes.Then select Save.Figure 187 AMP Setup > General > AMP Features Page Illustration3. After the VisualRF tab is visible, navigate to VisualRF > Setup.4. In the Server Settings section, select Yes in the Enable VisualRF Engine field. Then select Save.Figure 188 VisualRF > Setup > Server Settings SectionBasic QuickView NavigationThe top-level menus of VisualRF are split into two major categories: Network and Mesh, as shown in Figure 189and Figure 190. Selecting these menus will cause relevant submenus and sections to display below:Figure 189 Default VisualRF Top Level Menu - Network ViewFigure 190 Default VisualRF Top Level Menu - Mesh ViewTable 137 describes the top level icons and their functions on VisualRF.Table 137 Top Level Icons and DescriptionsOperation Icon DescriptionRefresh Refresh the floor plan to see changes.Open Site Tree Display the Network Tree View window on top of the floor plan.Preferences Configure personal viewing preferences. The Preferences menu allows youto configure user preferences (overlay types, grid lines, alerts, icon sizes).See “Configuring QuickView Personal Preferences” on page 266 for moredetails.Help Launch the online help.NOTE: This User Guide currently contains the most up-to-date helpinformation for the VisualRF interface.
