Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide Monitoring | 119Figure 93 Throughput GraphFor more information about the graphs in the virtual controller view and for monitoring procedures, see Table 13.Client Alerts LinkFor information about the Client Alerts link, see Chapter 3, “Instant User Interface” and Chapter 20, “Alert Typesand Management” chapters.IDS LinkFor information about the IDS link, see Chapter 3, “Instant User Interface” .Table 13 Virtual Controller View - Graphs and Monitoring ProceduresGraph Name Description Monitoring ProcedureClients The Clients graph shows the number of clientsassociated with the virtual controller for the last15 minutes.To see an enlarged view, click the graph. The enlarged view provides Last, Minimum,Maximum, and Average statistics for thenumber of clients associated with the VirtualController for the last 15 minutes. To see the exact number of clients in theDell Instant network at a particular time,hover the cursor over the graph line.To check the number of clients associatedwith the virtual controller for the last 15minutes,1. Log in to the Instant UI. The VirtualController view appears. This is thedefault view.2. Study the Clients graph in the UsageTrends pane. For example, the graph onthe left shows that one client isassociated with the virtual controller at11:43 hours.Throughput The Throughput graph shows the throughput ofall networks and IAPs associated with thevirtual controller for the last 15 minutes. Outgoing traffic - Throughput for outgoingtraffic is displayed in green. Outgoing trafficis shown above the median line. Incoming traffic - Throughput for incomingtraffic is displayed in blue. Incoming trafficis shown below the median line.To see an enlarged view, click the graph. The enlarged view provides Last, Minimum,Maximum, and Average statistics for theincoming and outgoing traffic throughput ofthe virtual controller for the last 15 minutes.To see the exact throughput of the Dell Instantnetwork at a particular time, hover the cursorover the graph line.To check the throughput of the networksand IAPs associated with the virtualcontroller for the last 15 minutes,1. Log in to the Instant UI. The VirtualController view appears. This is thedefault view.2. Study the Throughput graph in theUsage Trends pane. For example, thegraph on the left shows 2.0 kbpsoutgoing traffic throughput at 12:00hours. It also shows some incomingtraffic throughput at the same time.
