1-10 Rack Installation Guidew w w . d e l l . c o m | s u p p o r t . d e l l . c o m 5 Repeat step 1 through step 4 for the slide assembly on the other side of the rack.6 Ensure that the slide assemblies are mounted at the same position on the vertical railson each side of the rack.Installing the System in the RackCAUTION: If you are installing more than one system, install the first system inthe lowest available position in the rack.CAUTION: Never pull more than one component out of the rack at a time.1 Pull the two slide assemblies out of the rack until they lock in the fully extendedposition.CAUTION: Because of the size and weight of the system, never attempt to installthe system in the slide assemblies by yourself.2 Remove the system front bezel:a Unlock the keylock.b Press the right- and left-end tabs.c Pull the bezel away from the system.3 Lift the system into position in front of the extended slides.4 Place one hand on the front-bottom of the system and the other hand on the back-bottom of the system.5 Tilt the back of the system down while aligning the back shoulder screws on the sidesof the system with the back slots on the slide assemblies.6 Engage the back shoulder screws into their slots.7 Lower the front of the system and engage the front shoulder screws in the front slotbehind the system release latch (see Figure 1-7).The system release latch will move forward and then snap back as the shoulder screwpasses into the front slot.Use this system release latch when you wish to remove the system from the slideassemblies.8 Press the slide release latch at the side of each slide and push the system completelyinto the rack (see Figure 1-7).9 Push in and turn the captive thumbscrews on each side of the front chassis panel tosecure the system to the rack.5X860eb0.fm Page 10 Monday, October 21, 2002 11:49 AM