Dell PowerEdge FX2 Deployment Manual

Also see for PowerEdge FX2: Owner's manual Getting Started With Your System Owner's manual User guide Configuration guide

Contents

Dell PowerEdge FX2 Deployment Manual Manual pdf 61 page image

61 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2no shutdownexitinterface range te0/1-2description “Portchannellink to IOM”no switchportport-channel-protocol lacpport-channel 121 modeactiveexitno shutdownno shutdownexitinterface range te0/1-2description“Portchannel link toIOM”no switchportport-channel-protocollacpport-channel 121 modeactiveexitno shutdownS4810 VLT configurationNote: When you create a VLT domain on a switch, the system automatically assigns a unique unit ID(0 or 1) to each peer switch. Optionally, the unit ID can be manually configured as shown in theexamples above to minimize the time required for the VLT system to determine the unit ID assignedto each peer switch when one peer switch reboots.8.3 Environment Three: Verifying VLT ConnectivityVLT connectivity can be checked using the VLT commands listed in Table 11.show commandsCommand Purposeshow vlt brief Displays brief information about the VLT configurationshow vlt detail Displays running configuration for VLT membersshow mac-address-table Displays the MAC address tableOn each switch participating in VLT, perform a show vlt brief, show vlt detail and showmac-address-table. On the access switch, perform a show mac-address-table.show vlt briefThe Role (Primary or Secondary) should be appropriate for the switch. The status of the ICL Link,HeartBeat and VLT Peer must all be up.show vlt detailThis command shows the local LAG ID, the peer LAG ID, the local status of the VLT, the peer status ofthe VLT, and the active VLANs for the VLT.Columns Local Status and Peer status must be UP in order for the LAG to be functional.