Dell PowerEdge FX2 Owner's Manual

Also see for PowerEdge FX2: Owner's manual Getting Started With Your System Deployment guide User guide Configuration guide

Contents

Dell PowerEdge FX2 Owner's Manual Manual pdf 33 page image

● KVM panelSafety instructionsNOTE: Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system byyourself.NOTE: Opening or removing the system cover when the system is on may expose you to a risk of electric shock.NOTE: Exercise care when removing or installing components when the system is on, to avoid the risk of electric shock.CAUTION: Do not operate the system without the cover for a duration exceeding three minutes.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered byyour warranty. Read and follow the safety instructions that are shipped with your product.NOTE: It is recommended that you always use a static mat and static strap while working on components inside thesystem.NOTE: To ensure proper operation and cooling, all bays in the system must be populated at all times with either a sled orwith a blank.NOTE: Dell recommends that you remove the sleds and power supplies from the chassis to reduce weight, before installingthe enclosure in the rack.Before working inside your systemSteps1. Turn off the compute sleds by using either the CMC, iDRAC, or the compute sled power button.A storage sled turns off when the compute sled(s) to which it is mapped is turned off.2. Turn off the enclosure and attached peripherals, and disconnect the enclosure from the electrical outlet.After working inside your systemSteps1. Reconnect the enclosure to its electrical outlet and turn the enclosure on, including any attached peripherals.2. Turn on the compute sleds.A storage sled turns on when the compute sled(s) to which it is mapped is turned on.Recommended toolsYou need the following items to perform the procedures in this section:● #1 and #2 Phillips screwdrivers● T6, T8, T10, T15, and T20 Torx screwdrivers● Wrist grounding strap● Hex screw driverInstalling and removing PowerEdge FX2/FX2s enclosure components 33