Dell PowerEdge FX2 Owner's Manual
Also see for PowerEdge FX2: Owner's manualGetting Started With Your SystemDeployment guideUser guideConfiguration guide
                                                                                           | |
Contents
| 
ComputesledsSpecificationsUp to four PowerEdge FC430 compute sleds mixed with up to two PowerEdge FC630/FC640 computesleds, orOne PowerEdge FC830 compute sled mixed with up to two PowerEdge FC630/FC640 compute sledsStorage sleds SpecificationsPowerEdge FX2s Up to three PowerEdge FD332 storage sleds mapped to one PowerEdge FC630/FC640 compute sled, orUp to two PowerEdge FD332 storage sleds mapped to two PowerEdge FC630/FC640 compute sleds, orUp to two PowerEdge FD332 storage sleds mapped to up to four PowerEdge FC430 compute sleds, orUp to two PowerEdge FD332 storage sleds mapped to one PowerEdge FC830 compute sledNOTE: For more information on the technical specifications for the compute and storage sled(s), see the relevant sledOwner's Manual at Dell.com/poweredgemanuals.NOTE: For information on mapping of storage sleds to compute sleds in the PowerEdge FX2s enclosure, see the DellPowerEdge FD332 Owner's Manual at Dell.com/poweredgemanuals.Power specificationsPower supplyunitSpecificationsWattage 1100 W (1050 W for low line)1600 W (800 W for low line)2000 W (1000 W for low line)2400 W (1400 W for low line)Connector Card EdgeHeat dissipation 394 BTU/hr (full load for the power supply unit only) (1100 W power supply unit)475 BTU/hr (full load for the power supply unit only) (1600 W power supply unit)635 BTU/hr (full load for the power supply unit only) (2000 W power supply unit)760 BTU/hr (full load for the power supply unit only) (2400 W power supply unit)Maximum inrushcurrent25 ASystem voltagerequirements100 – 240 V ACNOTE: This system is also designed to be connected to IT power systems with a phase to phasevoltage not exceeding 230 V.Chassis Management Controller (CMC) specificationsExternallyaccessibleconnectorsSpecificationsRemotemanagementTwo dedicated 10/100/1000 Mb RJ-45 (for integrated Ethernet remote access controller). Gb portconnects to the CMC module’s external management network. STK port allows CMCs in adjacentenclosures to be daisy chained. The STK port can also be used for CMC NIC failover.Serial 9-pin, DTE, 16550-compatible86 Technical specifications—PowerEdge FX2/FX2s |
Related manuals for Dell PowerEdge FX2
Dell PowerEdge M1000E BMX01 Owner's Manual
Dell PowerVault MD3060e Owner's Manual
Dell SC400 Owner's Manual
Dell SCv300 Owner's Manual
Dell SC420F Owner's Manual
Dell MD1400 Owner's Manual
Dell PowerVault MD3000 Hardware Owner's Manual
Dell PowerVault MD1120 Hardware Owner's Manual
Dell PowerVault MD1000 Hardware Owner's Manual
Dell PowerVault MD3000i Hardware Owner's Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine