3. connector 4. KVM panel5. KVM panel coverNext stepsInstall the KVM panel.Related tasksInstalling the KVM panel on page 79Installing the KVM panelPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered byyour warranty. Read and follow the safety instructions that came with the product.NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certifiedservice technicians.1. Ensure that you read the Safety instructions on page 33.2. Follow the procedure listed in Before working inside your system on page 33.3. Remove the KVM panel.NOTE: You must remove the KVM panel to replace a faulty panel.Steps1. Connect the KVM panel cable to the KVM panel.2. Press the connector latch into place.3. Install the screw to secure the KVM panel cover to the KVM panel.4. Align the screw holes on the KVM panel with the screw holes on the side of the system.5. Install the two screws to secure the KVM panel to the side of the system.6. Insert the KVM panel cable in the cable tube.7. Align the screw holes on the cable tube with the screw holes on the side of the system.8. Install the three screws to secure the cable tube to the side of the system.Next stepsFollow the procedure listed in After working inside your system on page 33.Related informationRemoving the KVM panel on page 77Installing and removing PowerEdge FX2/FX2s enclosure components 79
