Dell PowerEdge M1000E BMX01 Owner's Manual

Also see for PowerEdge M1000e: Manual Command reference guide Owner's manual Update Getting started guide

Contents

Dell PowerEdge M1000E BMX01 Owner's Manual Manual pdf 24 page image

Configuring The CMC Using The LCD Configuration WizardWhen you first boot your system, the screen on the LCD module directs you to configure the CMC network settings.NOTE: The option to configure the enclosure using the LCD configuration wizard is only available until the CMCdefault password is changed or when the LCD configuration wizard is complete. Thereafter, use the RACADM CLIor the web-based GUI to change the CMC settings.NOTE: The serial null modem cable for the CMC is an option. You can access the CLI using the 17th blade featureon the embedded iKVM module. Blade number 17 is a direct local connection to the CMC.1. Choose a language from the options in the dialog box.2. Start the LCD configuration wizard.3. Configure the CMC network settings for your network environment.– Network speed– Duplex mode– Protocol (IPv4 and/or IPv6)– Network mode (DHCP or static)– Static IP address, subnet mask, and gateway values (if static mode was selected)– DNS setting, including a registered CMC name, (if DHCP mode was selected)NOTE: The CMC external management network mode is set by default to DHCP. To use a static IP address, youmust change the setting using the LCD configuration wizard.4. If required, configure the iDRAC network setting for DHCP mode.NOTE: You cannot set a static IP address for the iDRAC using the LCD configuration wizard. To set the static IPaddress, use the web-based interface.5. Review the settings on the Network Summary screen:– If the settings are correct, press the center button to close the configuration wizard and return to the MainMenu.– If the settings are not correct, use the left-arrow key to return to the screen for that setting and make theappropriate changes.The Network Summary screen lists the IP addresses for the CMC and the iDRAC network settings.After you complete the LCD configuration wizard, you can access the CMC on the network using the web-based CMCinterface or text-based interfaces such as a serial console, Telnet, or SSH.NOTE: If you want to use static addresses rather than DHCP to access the iDRACs, you must configure them usingthe CMC web-based interface or CLI.Configuring The CMC Using A Management Station And CLIThe LCD configuration wizard is the quickest way to initially configure the CMC network settings. However, you can alsouse a management station and a local connection to access the CMC.There are two ways to create a local connection to the CMC:• The CMC Console, using the optional iKVM. Press and select blade number 17.• Serial connection, using an optional null modem cable (115200 bps, 8 data bits, no parity, 1 stop bit, and no flowcontrol).24