I/O Modules—SwitchesConfiguring A Switch Module Network Ethernet Port Using The Web-Based InterfaceYou can use the CMC web-based interface to configure an I/O module’s Ethernet port.NOTE: Use this procedure to configure the switch’s out-of-band Ethernet port. The switch’s in-band managementIP address is configured through the switch’s external ports. These two IP addresses must be different, and ondifferent networks.NOTE: To change settings on the I/O module configuration page, you must have Fabric Administrator privileges forthe particular Fabric in which the module is installedNOTE: The network IP address set on the I/O module by the CMC is not saved to a configuration file. To save the IPaddress configuration permanently, use the connect switch-n RACADM command, or use a direct interfaceto the I/O module GUI.NOTE: Do not attempt to configure I/O module network settings for Ethernet pass-through or Infiniband switches.1. Log in to the CMC web-based interface.2. Select I/O Modules in the Chassis menu in the system tree.3. Select the Setup tab. The Configuring I/O Modules Network Settings page is displayed.4. Configure the switch for integration into your network.– Select DHCP Mode Enabled if your network uses a DHCP server to assign IP addresses.– If your network uses static IP addressing, enter an IP address, subnet mask and gateway.5. Click Apply.6. Click the Deploy sub-tab.After all I/O modules have been configured and connected, the enclosure’s blades can be inserted and booted with fullnetwork communication.Mellanox M4001F/M4001Q Infiniband Switch I/O ModuleThe Mellanox M4001F/M4001Q Infiniband switch delivers 56 Gb/s at FDR speed and 40 Gb/s at QDR speed (fullbisectional bandwidth per port). This switch module includes 16 Quad Small Form-factor Pluggable (QSFP) ports on thefront panel and 16 internal Infiniband ports. This Infiniband switch module is hot-swappable and may be installed inFabrics B or C.51
