NOTE: For more information on installing a processor/DIMM blank, see Removing A Processor/DIMM Blank.Figure 15. Removing and Installing a Processor1. processor2. processor shield3. notches in the processor (4)4. socket keys (4)5. pin-1 indicator (on the processor socket)6. pin-1 indicator (on the processor)7. socket-release leverInstalling A ProcessorCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.NOTE: If you are installing just one processor, it must be installed in socket CPU1.1. If applicable, remove the heat-sink blank.2. Unlatch and rotate the socket-release lever 90 degrees upward and ensure that the socket-release lever is fullyopen.3. Use the tab on the processor shield to rotate the processor shield upward and out of the way.4. If applicable, remove the socket protective cap from the processor shield. To remove the socket protective cap,push the cap from the inside of the processor shield and move it away from the socket pins.NOTE: It is recommended that you install/remove the socket protective cap from the processor shield with theprocessor shield in the open position.38
