Figure 21. Removing and Installing the Management Riser Card1. management riser card2. screws (3)3. system configuration jumpers4. management riser card connectorInstalling The Management Riser CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Install the management riser card on the blade system board:a) Lower the management riser card into place until the card connector fits into the corresponding connector onthe blade system board.b) Secure the management riser card to the blade system board with the three screws.2. Install the blade system board.3. Replace the mezzanine card.4. Reinstall the SSD backplane.5. Replace the SSD(s).If there are two SSDs, be sure to reinstall them in their original locations.6. Install the SD card and the vFlash card.7. Install the blade in the sleeve.Replacing The SD CardNOTE: The SD card in the lower card slot is the primary card (labeled as SD1) and the SD card in the upper cardslot is the secondary card (labeled as vFlash/SD2).1. Enter the System Setup and ensure that the Internal SD Card Port is enabled.50
