Dell PowerEdge M420 User Manual
Also see for PowerEdge M420: ManualCommand reference guideOwner's manualAdministrator's guideInformation update
                          | |
Contents
| 
Software User’s ManualRev 1.00123 Command Line Interface (CLI) Reference10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands describedin this section after successfully connecting to the 10GbE PTM CLI according to the proceduredescribed in Section 2, “Connecting to the 10GbE PTM CLI,” on page 8.3.1 CLI Privilege LevelsThe 10GbE PTM supports the following user privilege levels:• USER - Common user level, indicated by the # prompt• ADMIN - Administrator level, indicated by the & promptDifferent commands are available in different privilege levels. The command reference indicatesthe required privilege level for each command that requires a privilege level higher than USER.3.2 Quick ReferenceTable 5 provides a quick reference to the CLI commands:Table 5 - List of CommandsCommand name Short Description ReferenceGeneral Commandshelp Shows the list of available commands Section 3.4.1, “help,” on page 13exit Exit from the 10GbE PTM CLI Section 3.4.2, “exit,” on page 14login Change privilege level Section 3.4.3, “login (ADMIN),” onpage 14Software Image Commandsshow image ver Shows the software image version Section 3.5.1, “show image ver,” onpage 14copy image from-file Upload new software image to the 10GbE PTM Section 3.5.2, “copy image from-file,”on page 15Device Commandsshow device temp Shows the temperature of a specified device Section 3.6.1, “show device temp(ADMIN),” on page 15Port Commandsshow port link Shows port link state Section 3.7.1, “show port link,” onpage 16 |
Related manuals for Dell PowerEdge M420
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine