Dell PowerEdge M420 User Manual

Also see for PowerEdge M420: Manual Command reference guide Owner's manual Administrator's guide Information update

Contents

Dell PowerEdge M420 User Manual Manual pdf 19 page image

Dell 10Gb Ethernet Pass Through II Rev 1.00194 Operating Procedures4.1 Procedure for Updating SoftwareThe 10GbE PTM consists of three PhyX® devices and a micro-controller (CPU). This proceduredescribes how to update both CPU SW & PhyX® FW using a single .pfw binary file.The 10GbE PTM is delivered with the latest firmware available at the time of production. New fir-mare versions will be posted on the Dell support page. The latest firmware can be found at:http://support.dell.com/support/Step 1. Download the 10GbE PTM firmware .zip file and extract the .pfw binary file.Step 2. Connect to the 10GbE PTM using an SSH Client as described in Section 2, “Connecting tothe 10GbE PTM CLI,” on page 8.Step 3. From the CMC command line, connect to the 10GbE PTM CLI. Enter:Note: At least 20 seconds must have passed since the last power cycle of the 10GbE PTMmodule before running the following connect command.$ connect switch-where is the number of the switch -- 2 in our example.The prompt should change to #.Step 4. To start the upgrade process, run the command:# copy image from-fileThe system will now wait for a ".pfw" file to be transferred from the SSH client.Step 5. In your SSH client, initiate file transfer by pulling down the Transfers menu and clickingSend Files. Provide the path to the ".pfw" file and send it.

/ 26

Related manuals for Dell PowerEdge M420

Dell PowerEdge FN Getting Started Manual

Dell ConnectX MCQH29-XDR User Manual

This manual is suitable for:

PowerEdge M420 PowerEdge M520 PowerEdge M620 PowerEdge M820 Systems 10Gb Ethernet Pass Through II

manualsdatabase

Your AI-powered manual search engine