Expander cardRemoving an expander cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should beperformed only by Dell certified service technicians.NOTE: You must remove the expander card to replace a faulty expander card.NOTE: Ensure that you install an expander card if you are using 1.8 inch (x12) system.1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Keep the #1 and #2 Phillips screwdrivers ready.4. Remove the following:a. hard drives/SSDsb. hard drive/SSD backplanec. hard drive/SSD cageSteps1. Loosen the retention screws on the expander-card cable connector that connects to the connectoron the system board (J_PERC) and lift the cable up..CAUTION: To prevent damage to an expander card, hold the card only by its edges.2. Remove the screws that secure the expander card to the chassis.3. Lift the card away from the system.105
