CAUTION: To prevent damage to the rSPI card, hold the card only by its edges.NOTE: You must remove the rSPI card to replace a faulty rSPI card or service othercomponents inside the system.Steps1. Align the two screw holes on the rSPI card with the standoffs on the system board.2. Install the two screws to secure the rSPI card to the system board.Next steps1. Install the PCIe mezzanine card.2. Follow the procedure listed in After working inside your system.Related LinksRemoving the rSPI cardInstalling a PCIe mezzanine cardInstalling the system coverInstalling a server moduleSD vFlash cardYou can use an SD vFlash card with your system. The card slot is located on the IDSDM card. You canremove and install the SD vFlash cardReplacing the SD vFlash cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.Steps1. If installed, remove the SD vFlash card from the card slot.NOTE: The SD vFlash card slot is below the NDC.2. Insert the contact-pin end of the SD card into the card slot on the VFlash media unit.NOTE: The slot is keyed to ensure correct insertion of the card.3. Press inward on the card to lock it into the slot.67
