Option DescriptionMemory Frequency Sets the speed of the memory. You can select Maximum Performance, Maximum Reliability, or a specificspeed.Turbo Boost Enables or disables the processor to operate in the turbo boost mode. This option is set to Enabled bydefault.C1E Enables or disables the processor to switch to a minimum performance state when it is idle. This option isset to Enabled by default.C States Enables or disables the processor to operate in all available power states. This option is set to Enabled bydefault.Memory RefreshRateSets the memory refresh rate to either 1x or 2x. This option is set to 1x by default.Uncore Frequency Enables you to select the Processor Uncore Frequency option.Dynamic mode enables the processor to optimize power resources across the cores and uncore duringruntime. The optimization of the uncore frequency to either save power or optimize performance isinfluenced by the setting of the Energy Efficiency Policy option.Energy EfficientPolicyEnables you to select the Energy Efficient Policy option.The CPU uses the setting to manipulate the internal behavior of the processor and determines whether totarget higher performance or better power savings.Number of TurboBoot Enabled Coresfor Processor 1Controls the number of turbo boost enabled cores for processor 1. The maximum number of cores is enabledby default.Monitor/Mwait Enables the Monitor/Mwait instructions in the processor. This option is set to Enabled for all system profiles,except Custom by default.NOTE: This option can be disabled only if the C States option in the Custom mode is set todisabled.NOTE: When C States is set to Enabled in the Custom mode, changing the Monitor/Mwait settingdoes not impact the system power or performance.System Security Settings detailsThe System Security Settings screen details are explained as follows:Option DescriptionIntel AES-NI Improves the speed of applications by performing encryption and decryption by using the AdvancedEncryption Standard Instruction Set (AES-NI). This option is set to Enabled by default.System Password Sets the system password. This option is set to Enabled by default and is read-only if the password jumperis not installed in the system.Setup Password Sets the setup password. This option is read-only if the password jumper is not installed in the system.Password Status Locks the system password. This option is set to Unlocked by default.TPM Security NOTE: The TPM menu is available only when the TPM module is installed.Enables you to control the reporting mode of the TPM. The TPM Security option is set to Off by default.You can only modify the TPM Status, TPM Activation, and Intel TXT fields if the TPM Status field is set toeither On with Pre-boot Measurements or On without Pre-boot Measurements.TPM Information Changes the operational state of the TPM. This option is set to No Change by default.TPM Status Specifies the TPM status.42