CAUTION: When a replacement hot swappable hard drive is installed and the system is powered on, the hard drive automaticallybegins to rebuild. Make absolutely sure that the replacement hard drive is blank or contains data that you wish to have over-written. Any data on the replacement hard drive is immediately lost after the hard drive is installed.NOTE: Hot swappable hard drives are supplied in hot swappable hard drive carriers that fit in the hard drive slots.1 If installed, remove the front bezel.2 If installed, remove the hard drive carrier blank.3 Install a hot swappable hard drive into the hot swappable hard drive carrier.Steps1 Press the release button on the front of the hot swappable hard drive carrier and open the hot swappable hard drive carrier handle.2 Insert the hot swappable hard drive carrier into the hard drive slot, and push the hot swappable hard drive carrier until it comes incontact with the backplane.3 Close the hot swappable hard drive carrier handle to lock the hot swappable hard drive carrier in place.Figure 39. Installing a hot swappable hard drive carrier1 release button 2 hard drive carrier3 hard drive carrier handleNext stepIf removed, install the front bezel.Related linksSafety instructionsRemoving a 2.5-inch hard drive blankInstalling a hot swappable hard drive into a hard drive carrierInstalling the optional front bezelSafety instructionsRemoving a 2.5-inch hard drive blankRemoving the optional front bezelInstalling the optional front bezelInstalling a hot swappable hard drive into a hard drive carrier96 Installing and removing system components
