Operating with a setup password enabledIf Setup Password is set to Enabled, type the correct setup password before modifying the system setupoptions.If you do not type the correct password in three attempts, the system displays the following message:Invalid Password! Number of unsuccessful password attempts: System Halted!Must power down.Even after you turn off and restart the system, the error message is displayed until the correct password istyped. The following options are exceptions:• If System Password is not set to Enabled and is not locked through the Password Status option, youcan assign a system password. For more information, see System Security Settings screen.• You cannot disable or change an existing system password.NOTE: You can use the password status option with the setup password option to protect thesystem password from unauthorized changes.Embedded system managementThe Dell Lifecycle Controller provides advanced embedded systems management throughout theserver’s lifecycle. The Dell Lifecycle Controller can be started during the boot sequence and can functionindependently of the operating system.NOTE: Certain platform configurations may not support the full set of features provided by the DellLifecycle Controller.For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware,and deploying the operating system, see the Dell Lifecycle Controller documentation at Dell.com/idracmanuals.iDRAC Settings utilityThe iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. Youcan enable or disable various iDRAC parameters by using the iDRAC settings utility.NOTE: Accessing some of the features on the iDRAC settings utility requires the iDRAC EnterpriseLicense upgrade.For more information about using iDRAC, see iDRAC User's Guide at Dell.com/idracmanuals.Entering the iDRAC settings utility1. Turn on or restart the managed system.2. Press F2 during Power-on Self-test (POST).3. On the System Setup Main Menu page, click iDRAC Settings.The iDRAC Settings screen is displayed.36