Dell PowerEdge T410 Hardware Owner's Manual

Also see for PowerEdge T410: Manual Installation Update Technical guide Update

Contents

About Your System 43Alert! AdvancedECC Memory Modedisabled! Memoryconfigurationdoes not supportAdvanced ECCMemory Mode.Advanced ECC MemoryMode was enabled in thesystem setup program, butthe current configurationdoes not support AdvancedECC Memory Mode. Amemory module may befaulty.Ensure that the memorymodules are installed in aconfiguration that supportsAdvanced ECC MemoryMode. Check other systemmessages for additionalinformation for possiblecauses. For memoryconfiguration information,see "General MemoryModule InstallationGuidelines" on page 106. Ifthe problem persists, see"Troubleshooting SystemMemory" on page 162."Alert! iDRAC6 notresponding.Rebooting.The iDRAC6 is notresponding to BIOScommunication eitherbecause it is not functioningproperly or has notcompleted initialization. Thesystem will reboot.Wait for the system toreboot.Alert! iDRAC6 notresponding.Power requiredmay exceed PSUwattage.Alert!Continuingsystem bootaccepts the riskthat system maypower downwithout warning.The iDRAC6 has hung.The iDRAC6 was remotelyreset while system wasbooting.After AC recovery, theiDRAC6 takes longer thannormal to boot.Remove AC power to thesystem for 10 seconds andrestart the system.Table 1-3. System Messages (continued)Message Causes Corrective Actions