3. Remove the two screws that secure the Network Daughter Card/LOM riser card to the system board.4. Lift the card from the system board.5. Close the server module.6. Install the server module in the enclosure.Figure 15. Removing and Installing the Network Daughter Card/LOM Riser Card1. LOM riser card2. screws (2)3. LOM riser card connector4. standoffs (2)5. tab projections (on the plastic bracketcovering the PCIe mezzanine cardconnectors)Installing The Network Daughter Card/LOM Riser CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Remove the server module from the enclosure.2. Open the server module.3. Install the Network Daughter Card/LOM riser card:a) Align the slots on the card edge with the projection tabs on the plastic bracket covering the PCIe mezzaninecard slots.b) Lower the card into place until the card connector fits into the corresponding connector on the system board.c) Secure the card with the two screws.4. Close the server module.5. Install the server module in the enclosure.44
