Indicator DescriptionBlinking Green Warm-plug operation is in progress and insertion or removal of theadapter is not allowed.Off Power supply to the slot is off, and the expansion card can beremoved.Slot attentionindicator Steady Amber The adapter or slot is in a fault condition.Blinking Amber The indicator blinks for 15 seconds after the slot identify command.Off The slot is operating normally, or no expansion card is installed in theslot.Removing A Low Profile Expansion CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.NOTE: The system must be closed to initiate expansion card discovery in the CMC.1. Turn off the server module to which the expansion card is assigned, using the operating system commands or theCMC.2. Open the system.3. Disconnect any cables connected to the expansion card.4. Press the release tab of the expansion-card latch to lift the latch out of the chassis slot.5. Grasp the expansion card by its edges, and remove it from the expansion-card connector.6. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening andclose the expansion-card latch.NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal CommunicationsCommission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid inproper cooling and airflow inside the system.7. Close the system.8. Turn on the server module using the operating system commands or the CMC.74
