Deleting a Diagnostics Log FileTo delete an existing diagnostics log file from the Diagnostics summary table on the Diagnostics page, complete thefollowing:1. Select Support → Diagnostics.The Diagnostics page is displayed.2. Click Select to select the diagnostics file you want to delete, and click Delete.The Delete Confirmation dialog is displayed.3. Click OK to delete the selected diagnostics log file (or click Cancel to display the Diagnostics page).The Log file was removed successfully dialog is displayed when successful.DR Series System Software UpgradeWhen you initiate a DR Series system software upgrade, the navigation panel displays only the Support page and theSoftware Upgrade options.The administrator that initiated the software upgrade (considered the initiator administrator) will see a SystemInformation pane that displays an alert that readsIMPORTANT: Please do not navigate out of this screen until theupgrade is finished, and displays the upgrade status asUpgrade in Progress... Please wait.... The Current Version andUpgrade History versions of the DR Series system software are listed in the Software Info pane.All other administrators that may be logged into DR Series system (with the exception of the initiator administrator whostarted the software upgrade), will only see a dialog that displaysStatus: The system is being upgraded. Wait for it tobecome operational..There are only three possible outcomes during a DR Series system software upgrade operation:• The upgrade operation completed successfully—no reboot is required.• The upgrade operation completed successfully—but a reboot is required (click Reboot in the Software Upgradepage).• The upgrade operation failed.Software Upgrade Page and OptionsUse the Software Upgrade page to verify the current installed version of the DR Series system software in the SoftwareInformation pane, or to apply updates to the system. There are two methods you can use to display the SoftwareUpgrade page:• Using the Support page, click Software Upgrade.• Using the navigation panel, select Support → Software Upgrade.Both methods display the Software Upgrade page where you can verify the current installed version, check the upgradehistory of previously installed software versions, verify the iDRAC IP address (if one is in use), start the upgrade process,or reboot the DR Series system using the options on this page.NOTE: During the DR Series system software upgrade, the upgrade status "starting" remains displayed duringalmost the entire duration of the software upgrade process. It is not until the DR Series system upgrade statuschanges to "almost done" that the system upgrade process has fully completed.118
