– Unlimited: this defines the allowed amount of incoming raw data per container (based on the physicalcapacity of the container).– Size: this defines a set limit in Gibibytes (GiB) for incoming raw data allowed per container.7. Click Create a New Container (or click Cancel to display the Containers page).After creating the new container, the Containers page is displayed and includes a Successfully Added dialog. Thelist of containers in the Containers summary table is updated with your new container (and its new status isreflected as N/A in the Replication column of this table).Creating an Unassigned Connection Type ContainerTo create an unassigned container in the DR Series system without a defined connection type (None), complete thefollowing:NOTE: The DR Series system allows you to create a container without configuring it with a specific connectiontype. When you are ready to configure an unassigned container at a later date, select it in the Containers summarytable, click Edit, and configure it with the desired connection type.1. Select Storage → Containers.The Containers page is displayed showing all existing containers.2. Click Create.The Create New Container dialog is displayed.3. In Container Name, type the name of the container.Container names cannot exceed 32 characters in length, and can be composed of any combination of the followingcharacters:NOTE: The DR Series system does not support the use of the following special characters in containernames: /, #, or @.– A-Z (uppercase letters)– a-z (lowercase letters)– 0-9 (numbers)– dash (-) or underscore (_) special characters4. In Marker Type, select from the following choices: None, Auto, CommVault, Networker, TSM, or ARCserv.If you select the Auto marker type, this will enable all marker types to be detected. As a best practice, if you haveonly one type of DMA with traffic directed to a container, it is best to select the corresponding marker type (forexample, CommVault). Conversely, as a best practice, if you have traffic from a DMA that is not one of thesupported marker types, it is best to disable marker detection for the container by selecting the None marker type.5. To create a container with an unassigned connection type, select None to create a container for configuration at alater time or to disable any specific marker type for the container.6. Click Create a New Container (or click Cancel to display the Container Summary page).After creating a new container, the Containers page is displayed and displays a Successfully Added dialog. The listof containers in the Containers summary table is updated with your new unassigned container.Editing Container SettingsTo modify any of the settings for an existing container, complete the following:1. Select Storage→ Containers.The Containers page is displayed, and lists all current containers.2. Click Select to identify the container in the list that you want to modify, and click Edit.90
