Typing Your System PasswordWhen you start or restart your computer, one of the following prompts appears on the screen.If Password Status is set to Unlocked:Type in the password and- press to leave password security enabled.- press to disable password security.Enter password:If Password Status is set to Locked:Type the system password and press .Enter password:If you have assigned a setup password, the computer accepts your setup password as an alternate system password.If you type a wrong or incomplete system password, the following message appears on the screen:** Incorrect password. **If you again type an incorrect or incomplete system password, the same message appears on the screen. The third and subsequent times you type anincorrect or incomplete system password, the computer displays the following message:** Incorrect password. **Number of unsuccessful password attempts: 3System halted! Must power down.Even after your computer is turned off and on, the previous message is displayed each time you type an incorrect or incomplete system password.Changing or Deleting an Existing System PasswordTo change a system password, follow the procedure in Assigning a System Password.To delete a system password:1. Enter system setup (see Entering System Setup), highlight System Password and press .2. When prompted, type the system password.3. Press twice to clear the existing setup password. The setting changes to Not Set.4. To assign a new password, follow the procedure in Assigning a System Password.Admin PasswordOption Settingsl Set — Does not allow assignment of setup passwords; users must enter a setup password to make changes to system setupl Not Set — Allows assignment of setup passwords; password feature is enabled but no password is assignedl Disabled —The administrator password is disabled by a jumper setting on the system boardAssigning a Setup PasswordThe setup password can be the same as the system password.1. Enter system setup (see Entering System Setup) and verify that Admin Password is set to Not Enabled.2. Highlight Admin Password and press the left- or right-arrow key.NOTE: You can use Password Status in conjunction with System Password and Admin Password to further protect your computer from unauthorizedchanges.NOTE: If the two passwords are different, the setup password can be used as an alternate system password. However, the system password cannotbe used in place of the setup password.