Dell Precision 620 User Manual

Also see for Inspiron 620: Setup guide Upgrade manual System information guide Quick start Quick reference guide

Contents

9. Connect the appropriate interface cable to the interface connector on the back of the drive (see Figure 9).If your system came with an EIDE CD-ROM or tape drive, use the spare connector on the existing interface cable. Otherwise, use theEIDE or SCSI cable provided in the drive kit.10. For an EIDE tape drive, LS-120 SuperDisk drive, or CD-ROM drive, connect the other end of the interface cable to the interface connectorlabeled "IDE2" on the system board (see Figure 1 in "Installing System Board Options").For a SCSI drive, connect the cable from the drive to the interface connector labeled "SCSI_NARROW" on the system board.For a diskette drive, connect the cable from the drive to the interface connector labeled "DISKETTE" on the system board.For a drive that comes with its own controller card, connect the other end of the interface cable to the controller card.11. Check all cable connections. Fold cables out of the way to provide airflow for the fan and cooling vents.12. If the 5.25-inch drive bay was previously empty, remove the front-panel insert from the front cover.13. Replace the front bezel.14. Replace the computer cover.15. Reconnect your computer and peripherals to their power sources, and turn them on.ALERT! Cover was previously removed.16. To reset the chassis intrusion detector, enter System Setup, select System Security, and reset Chassis Intrusion to Enabled, Enabled-Silent, or Disabled.17. Update your system configuration information.For a diskette drive, update the appropriate Diskette Drive category (A or B) on Page 1 of the System Setup screens to reflect thesize and capacity of your new diskette drive.For EIDE CD-ROM and tape drives, set the appropriate Drive category (0 or 1) under Drives: Secondary to Auto.18. Verify that your system works correctly by running the Dell Diagnostics.See your Diagnostics and Troubleshooting Guide for information on running the Dell Diagnostics and troubleshooting any problemsthat may occur. Use the following guidelines to determine which test to use:l If you installed a diskette drive, test it by running all of the subtests in the Diskette Drives test group of the Dell Diagnostics.l If you installed a CD-ROM drive, see the documentation that came with the drive for instructions on loading device drivers and using the1 DC power cable2 Power input connector3 Interface connector4 EIDE cable for tape driveNOTICE: You must match the colored strip on the cable with pin 1 on the drive's interface connector to avoid possible damage toyour system.NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to bedisplayed at the next system start-up:NOTE: If a setup password has been assigned by someone else, contact the network administrator for information onresetting the chassis intrusion detector.