108 Troubleshooting Your ProjectorGuiding SignalsProjectorStatus DescriptionControl Buttons IndicatorPower TEMP(Amber)LAMP(Amber)Standby mode Projector in Standby mode. Ready topower on.BLUEFlashing OFF OFFWarming upmodeProjector takes some time to warm upand power on. BLUE OFF OFFLamp on Projector in Normal mode, ready todisplay an image.Note: The OSD menu is not accessed.BLUE OFF OFFCooling mode Projector is cooling to shutdown. BLUE OFF OFFPower SavingmodePower Saving mode has been activated.The projector will automatically enterstandby mode, if an input signal is notdetected in two hours.AMBERFlashing OFF OFFCooling beforePower SavingmodeThe projector takes 60 seconds to cooldown before entering Power Savingmode.AMBER OFF OFFProjectoroverheatedAir vents might be blocked or ambienttemperature may be above 35ºC. Theprojector automatically shuts down.Ensure that the air vents are not blockedand that the ambient temperature iswithin operational range. If the problempersists, contact Dell.OFF AMBER OFFLamp driveroverheatedThe lamp driver is overheated. The airvents may be blocked. The projectorautomatically shuts down. Turn thedisplay on again after the projector coolsdown. If the problem persists, contactDell.AMBER AMBER OFFFan breakdown One of the fans has failed. The projectorautomatically shuts down. If the problempersists, contact Dell.ÒFF AMBERFlashing OFFLamp driverbreakdownThe lamp driver has failed. The projectorautomatically shuts down. Unplug thepower cord after three minutes then turnthe display on again. If this problempersists, contact Dell.AMBERFlashing OFF AMBERFlashingColor WheelbreakdownColor wheel cannot start. The projectorhas failed and the projectorautomatically shuts down. Unplug thepower cord after three minutes and thenturn on the projector. If this problempersists, contact Dell.BLUE AMBERFlashingAMBERFlashing