110 Troubleshooting Your ProjectorInteractive Pen LED Guiding SignalsPen Status Description Indicator Checking flow and items / timesGreen color Amber colorNormal mode Pen faces thescreen with thelink.Solid ON OFFStandby mode Pen doesn’t facesthe screen but withthe link.Flashing0.1s ON/1s OFF OFF Will enter Sleep mode after 3minutes.Finding AP thenenter pairingFind AP then enterPairing mode. Flashing Flashing Flash Amber one time, next flashGreen one time, then turn off both.Search mode When you searchfor a channel andno signal isavailable, LEDGreen & Amberwill blink 1 time.Flashing0.1 sec.Flashing0.1 sec.When you search for a channel andno signal is available, LED Green &Amber will blink 1 time.Sleep mode Enter Sleep modefor power savingpurpose.Solid ON3 sec.Solid ON3 sec.•Set the Interactive to OFF onOSD menu when using pen withthe link: will enter Sleep modeafter 5 sec.•Pen doesn't face the screen butwith the link: will enter Sleepmode after 3 minutes.•Reloading the battery will restartor reset first. After searching forAP channel 3 cycles without a link,will enter Sleep mode.Reset Pairing or linkingfailure will performthe resetautomatically.Flashing Flashing Green and Amber LED flashalternatively. The total is 3 times.Low batterycapabilityThe pen battery islow. Two hours areleft to run out ofthe battery. OFF Flashing1s On & 1s OFFThe MSP430 will check batterycapacity in normal operation. Thisalert LED signal is shown if thebattery capacity is low.Note: This signal is shown onlywhen pen faces the interactivescreen.Battery isexhausted andcan not run PB.The Photo sensorand RF modulecannot workproperly. Pen cannot work normally. OFF Solid ONThe pen battery is exhausted. Poweronly works for MSP430. The alertLED will appear 1 minute to savepower and then enter Standbymode. Pen cannot be used in thisstatus.Note: This signal is shown onlywhen the pen faces the interactivescreen.