• If one or more of the system setup tasks fails, click Troubleshoot Initialization Error to learn how to resolve the issue.• If the Configuring Disks task fails, click View Disks to see the status of the drives detected by the Storage Center.• If any of the Storage Center front-end ports are down, the Storage Center Front-End Ports Down dialog box opens. Select theports that are not connected to the storage network, then click OK.2 When all of the Storage Center setup tasks are complete, click Next.Configure Key Management Server SettingsThe Key Management Server Settings page opens if the Storage Center is licensed for SEDs. Use this page to specify the keymanagement server network settings and select the SSL certificate files.1 Specify the network settings for the key management server.2 If the key management server is configured to verify client certificates against credentials, type the user name and password of thecertificates.3 Select the key manager server certificate files.4 Click Next.Create a Storage TypeSelect the datapage size and redundancy level for the Storage Center.1 Select a datapage size.• Standard (2 MB Datapage Size): Default datapage size, this selection is appropriate for most applications.• High Performance (512 KB Datapage Size): Appropriate for applications with high performance needs, or in environments inwhich snapshots are taken frequently under heavy IO. Selecting this size increases overhead and reduces the maximum availablespace in the Storage Type. Flash Optimized storage types use 512 KB by default.• High Density (4 MB Datapage Size): Appropriate for systems that use a large amount of disk space and take snapshotsinfrequently.2 Modify the redundancy for each tier as needed.• For single-redundant RAID levels, select Redundant.• For dual-redundant RAID levels, select Dual Redundant.3 To have the system attempt to keep existing drives on the same redundancy level when adding new drives, select the Attempt tomaintain redundancy when adding or removing disks check box.4 Click Next.Configure PortsSet up Fibre Channel, iSCSI and SAS ports.1 Select the check box of each type of port you want to configure. You must select at least one type to continue.NOTE: If a port type is grayed out, no ports of that type have been detected.2 Click Next.Configure Fibre Channel PortsFor a Storage Center with Fibre Channel front-end ports, the Review Fault Domains page displays information about the fault domains thatwere created by the Storage Center.PrerequisiteOne port from each controller within the same fault domain must be cabled.NOTE: If the Storage Center is not cabled correctly to create fault domains, the Cable Ports page opens and explains the issue.Click Refresh after cabling more ports.62 Discover and Configure the Storage Center